Log In
December 27, 2024
Offline
I hope I don’t get banned for this un-gun question, but you guys seem to be a knowledgeable bunch… if I need to rivet a baffle back into a Harley exhaust pipe – considering heat and vibration – would a steel or aluminum rivet be the better choice?
Dan #67288
April 15, 2005
Online
Deg said
I hope I don’t get banned for this un-gun question, but you guys seem to be a knowledgeable bunch… if I need to rivet a baffle back into a Harley exhaust pipe – considering heat and vibration – would a steel or aluminum rivet be the better choice?
Steel… stainless if you can find them.
WACA Historian & Board of Director Member #6571L
December 27, 2024
Offline
I was wondering about stainless – and if I can find them. Thank you!!
Dan #67288
May 2, 2009
Offline
https://www.mcmaster.com/products/rivets/rivet-type~solid/material~stainless-steel-2/
Stainless will be harder to set than steel.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
1 Guest(s)
