Log In
October 29, 2011
Offline
Anyone know where we could find this?
November 7, 2015
Offline
No idea, is it based on the Hornet or Bee case?
Mike
October 29, 2011
Offline
Mike–based on the bee case..Bill
November 19, 2006
Offline
So this round takes .20 caliber bullets?
March 12, 2008
Offline
I have built several of these for falling block single shot varmint rifles. It is a very simple round to make and load. Just neck down a factory 218 Bee to 20 caliber, load and fire form in your rifle. Super little round out to about 200 yards.
Steve
March 31, 2009
Offline
seewin said
I have built several of these for falling block single shot varmint rifles. It is a very simple round to make and load. Just neck down a factory 218 Bee to 20 caliber, load and fire form in your rifle. Super little round out to about 200 yards.
Steve
That’s interesting. I could not find any info for this. A lot of info for the one made from the Hornet.
March 12, 2008
Offline
I just marked up a 22 Ackley Bee reamer to the dimensions I wanted, and had JGS grind it. I’m a 20 cal nut and have done several different 20’s like that. Currently developing loads for a 20 ARC that I had JGS grind for me.
Steve
March 31, 2009
Offline
I’m well aware of JGS. My new 284 Shehane was probably cut by a JGS reamer.
November 19, 2006
Offline
I thought I knew things. This thread is proof I don’t 
March 31, 2009
Offline
seewin said
I just marked up a 22 Ackley Bee reamer to the dimensions I wanted, and had JGS grind it. I’m a 20 cal nut and have done several different 20’s like that. Currently developing loads for a 20 ARC that I had JGS grind for me.
Steve
What action are you using for the ARC?
1 Guest(s)
