Forum -

Winchester Model 1886

Richard Pike

Member

WACA Member

Forum Posts: 94

Member Since:
September 14, 2016

Offline

November 11, 2016 - 5:49 pm

I am looking for a Lyman #1 sight for a Winchester Model 1886. Must have only an “N” stamped on the bottom. Also would prefer one that the finish is in very good condition.

And, if it is not too much to ask. I don’t want to take out a second mortgage to afford it. Laugh

Thanks, Dick Pike

Manuel

Member

WACA Member

Forum Posts: 554

Member Since:
February 19, 2013

Offline

November 11, 2016 - 9:57 pm

There is one on ebay that is in almost 100% condition with the original box for 600 or best offer. You might want to check that out…

1873man

Wisconsin

Member

WACA Member

Forum Posts: 4995

Member Since:
May 2, 2009

Offline

November 11, 2016 - 11:09 pm

$600 is too much for a sight to go on the gun. Your paying a couple hundred for the box.

Bob

WACA Life Member---
NRA Life Member----
Cody Firearms member since 1991
Researching the Winchester 1873's

Email: [email protected]

Richard Pike

Member

WACA Member

Forum Posts: 94

Member Since:
September 14, 2016

Offline

November 12, 2016 - 3:33 pm

Thank you for your replies. The sight on Ebay is marlk “N 1” which according to my research was only used on Model 1886 in .33 Cal.

I wouldn’t pay $600 even if it was the correct sight.

Thanks, Dick

deerhunter

Troutdale, OR

Member

WACA Member

Forum Posts: 3077

Member Since:
June 26, 2013

Offline

November 18, 2016 - 11:13 pm

Here’s an “N” coded one on ebay right now:

http://www.ebay.com/itm/Lyman-1-Combination-Tang-Peep-Sight-N-for-Winchester-1886-86-except-33-cal-/311742165352?hash=item489547f168:g:nTYAAOSwiONYLHP9

Forum Timezone: UTC 0

Most Users Ever Online: 21294

Currently Online: keith shaffer, btbell, [email protected], Zebulon, Jeremy P, Pwog

Guest(s) 293

Currently Browsing this Page:
1 Guest(s)

Winchester Model 1886|Winchester Swap Meet|Forum|Winchester Collector