Log In
October 12, 2015
Offline
Looking for a for end, for end cap and both cap retainer screws.
Any help would be appreciated.
I have LOTS of old lever action parts I will trade or…..?
May 2, 2009
Offline
You need to tell us what caliber and barrel shape.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
October 12, 2015
Offline
44 cal.
24″ barrel
full octagon.
Sorry, I am new at these forums and am really struggling navigating this site.
Thanks for your patience.
May 2, 2009
Offline
I would look at Ebay for that. The forearm and cap must be a from a 44 to fit since the barrel on the 44 is larger in size you could use a forearm from a round barrel but would require some fitting.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
April 20, 2011
Offline
is the forend cap on a 1873, the same as a 1892 cap?
May 2, 2009
Offline
It all depends on what calibers your comparing. The 73 could have 6 different caps depending on caliber and barrel shape.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
April 20, 2011
Offline
would it be the same size from a 44-40 oct. barrel made in the same year
May 2, 2009
Offline
I don’t have any 92’s to make a comparison. If you have a micrometer, measure the width of the barrel at the fore end, mag tube diameter and the width of the wood then I’ll check a 73.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
1 Guest(s)
