Log In
September 22, 2011
Offline
This globe sight has no tension whatsoever. One would think that tightening the screw on the left side of the sight would increase tension. But it has no effect, any attempt to further tighten is unlikely to tighten but rather lead to damage to the screw head. Any suggestions? Or best to just let sleeping dogs lie, except it’s doubtful the rifle left the factory this loose.
May 2, 2009
Offline
That is a Lyman #5 combination front sight and you can normally tighten the friction by tightening the screw. Have you tried both screws? Remove the screw and inspect it. The pin end of the screw could of been broken off. The beach sight has a spring in the base that kept it in place.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
September 22, 2011
Offline
1873man said
That is a Lyman #5 combination front sight and you can normally tighten the friction by tightening the screw. Have you tried both screws? Remove the screw and inspect it. The pin end of the screw could of been broken off. The beach sight has a spring in the base that kept it in place.
Bob
I’ll have to have a look over the weekend. I didn’t realize there was a screw on the other side as well, but it makes sense.
Bert, I can’t change my title, but Glove should be GLOBE. Please revise.
July 17, 2012
Offline
mrcvs said
Bert, I can’t change my title, but Glove should be GLOBE. Please revise.
I am Bert’s MUCH younger brother JWA and I took care of the title for you. 
WACA Life Member #6284 - Specializing in Pre-64 Winchester .22 Rimfire
April 15, 2005
Offline
JWA said
mrcvs said
Bert, I can’t change my title, but Glove should be GLOBE. Please revise.
I am Bert’s MUCH younger brother JWA and I took care of the title for you.
Yes, I am a “Boomer” whereas JWA is a “Gen X’r. With age comes wisdom… grasshopper!
WACA Historian & Board of Director Member #6571L
July 17, 2012
Offline
Bert H. said
JWA said
mrcvs said
Bert, I can’t change my title, but Glove should be GLOBE. Please revise.
I am Bert’s MUCH younger brother JWA and I took care of the title for you.
Yes, I am a “Boomer” whereas JWA is a “Gen X’r. With age comes wisdom… grasshopper!
I am a late “Boomer” and a byproduct of the Cold War but still young at heart, just not in the mirror.
WACA Life Member #6284 - Specializing in Pre-64 Winchester .22 Rimfire
1 Guest(s)
