Log In
February 3, 2019
Offline
I picked this up at the swap meet today, hoping it would fit my latest project. the wrist area is a bit narrow on a 1912 winchester 94 rifle. I need a buttplate but the contour ends with a curve on top. does this look like a factory stock? it’s also very light, a guy at the swap meet said maybe it’s gum wood? thanks. 
May 2, 2009
Offline
Looks like it had tacks in it. You need to show the inletting to see if its original wood or homemade.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
February 3, 2019
Offline
pics added. the wrist area is 1.5 inches. jim
May 2, 2009
Offline
It does not look like the typical 94 stock inletting I’ve seen.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
February 3, 2019
Offline
thanks, is it possible its a different model? the seller had no idea what it was or for, I just too a chance on it. jim
February 3, 2019
Offline
I pulled the stock off my 1890 and the cuts (inletting?) is longer on the mystery stock. the wrist on the 1890 is also about 1.5 inches like the mystery stock. if I slide the stock on a 1894 rifle the tang sits above the wood and the lower tang sits below the wood. jim
1 Guest(s)
