Log In
I have a deluxe Model 64 in 30WCF, it has the factory installed swivel bases but I can’t seem to find a set of swivels to fixt the gun. The aftermarket swivels I’ve checked have too short of a pin. What type of swivel do I need to use on the gun so I can install a sling?? Thanks
April 15, 2005
Online
Jim,
While I am not 100% sure about this, I suspect that the QD swivels used on the Model 70 rifles are the same as those used on the Model 64 Deer Rifle. Maybe one of our regulars was the correct catalog to look up the part numbers for them.
Bert
WACA Historian & Board of Director Member #6571L
March 12, 2008
Offline
Bert, you are correct. Same swivels as model 70 Super Grade (1″ variety), 71 deluxe and the 52 Sporter as well. There were 2 widths of these made by Winchester to accommodate both the 1″ & 1-1/4″ wide sling. The 1″ is by far the more common and correct for the 64. They are always for sale on the internet sites. Here is a set:
I cannot vouch that they are originals, but seller should know.
Steve
December 31, 2012
Offline
seewin said
Bert, you are correct. Same swivels as model 70 Super Grade (1″ variety), 71 deluxe and the 52 Sporter as well. There were 2 widths of these made by Winchester to accommodate both the 1″ & 1-1/4″ wide sling. The 1″ is by far the more common and correct for the 64. They are always for sale on the internet sites. Here is a set:I cannot vouch that they are originals, but seller should know.
Steve
Yep, and again my thanks to you Steve. Big Larry
1 Guest(s)
