Log In
April 12, 2007
Offline
I have a model ’94 with a set trigger and when you pull the hammer all the way back , set the trigger , and fire , the hammer only falls to the 1/2 cock position. It doesn’t fall all the way to the firing pin. The hammer spring feels to me like it is stout enough. Any ideas ? Thanks , Ken
May 2, 2009
Offline
Ken
On a set trigger at least a single set trigger there is a little pivoting piece on the hammer called the fly. It there to carry the sear over the half cock when the set trigger is used. My guess is the fly is missing or has a problem. The sear is being kicked of the hammer notch but falls into the half cock.
Here is a link to a set trigger article.
http://www.tapaderaswinchesters.com/newsletter.html
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
April 12, 2007
Offline
this one is a double set. It must encorporate a fly also ??
May 2, 2009
Offline
Ken,
I assume it would have to use a fly.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
1 Guest(s)
