November 18, 2026
OfflineGood day, new member here. I was wondering if anyone has come across a Model 1866 with a slot cut for a Mortise cover? I found a picture of one in John E. Parsons “The First Winchester” as well as on page 89 of “The Winchester Book”? I picked up a silver plated 66 with a slot, at first I thought it may have been done after it left the factory, however you can see the slot in the top of the breech bolt that would open the cover. Cody letters are not available for serial numbers starting with 26***. Any help would be greatly appreciated. Thank you.
December 9, 2002
OfflineWin-man65 said
Good day, new member here. I was wondering if anyone has come across a Model 1866 with a slot cut for a Mortise cover? I found a picture of one in John E. Parsons “The First Winchester” as well as on page 89 of “The Winchester Book”? I picked up a silver plated 66 with a slot, at first I thought it may have been done after it left the factory, however you can see the slot in the top of the breech bolt that would open the cover. Cody letters are not available for serial numbers starting with 26***. Any help would be greatly appreciated. Thank you.
Welcome Christopher,
I copied this past post from a few months back, that member martin rabeno asked me to post, that I think can help out here, with you’re Quest.
Tony
May 2, 2009
OfflineTony,
This is a slot behind the elevator slot running long ways. The picture caption in the Madis book said it was for a dust cover but I’m guessing it could of been a aftermarket attempt to put a cover one it. The Madis picture is not very good to see detail.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's

Email: [email protected]
May 2, 2009
OfflineWhat would really be helpful is post some good pictures if it since the pictures in the Madis book are very poor.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's

Email: [email protected]
1 Guest(s)
Log In
