Forum -

Bert - 405 Highwall

Chuck

Member

WACA Member

Forum Posts: 6735

Member Since:
March 31, 2009

Offline

March 22, 2020 - 6:38 pm

Did I give you all of the information you need to add this gun to your survey?

Bert H.

Kingston, WA

Admin

Forum Posts: 14393

Member Since:
April 15, 2005

Offline

March 22, 2020 - 6:41 pm

Chuck said
Did I give you all of the information you need to add this gun to your survey?

Chuck,

I am not adding it to the survey because I am relatively certain that it is not factory original.

Bert

WACA Historian & Board of Director Member #6571L

Chuck

Member

WACA Member

Forum Posts: 6735

Member Since:
March 31, 2009

Offline

March 22, 2020 - 7:15 pm

I agree with you Bert. Just make note of the serial number. I do have a question about the forend. Is there a difference underneath where the machine cuts were done? Most that I have looked at have a much deeper and longer cut. Did this cut change when the spring type was changed? What made you think this was once an octagon forend?

Here is the only picture of the underside.