bamajim31
New Member
WACA Guest
Forum Posts: 2
Member Since:
September 6, 2024
September 6, 2024
OfflineHi everyone
I am in the process of doing a restoration on a pre 64 model 94. Is there any information availabe that tells what the thread pitch is for the bolts and screws. I have had to drill out some of the screws because they where rusted if place. I would like to chace the threads before replacing the screws. My thread gauge does not go down to the extra fine thread sizes that where used. The screw that I am concerned about is the hammer screw. The replacement screw is appears to be No 10 with a finer thread than a 40 pitch, mayber a 48 pitch. The bolt will not thread into the receiver. The threads in the receiver may be buggered up so I feel the need to chace the threads.
Jim
Forum Timezone: UTC 0
Most Users Ever Online: 21294
Currently Online: steve004, 1892takedown, tionesta1 (AL), TXGunNut, Bill Hanzel, Bryan Austin, Turbo 1886, Mopglen, Honest Jon, IndianCent
Guest(s) 428
Currently Browsing this Page:
2 Guest(s)
2 Guest(s)
Top Posters:
TXGunNut: 7773
clarence: 7119
Chuck: 6931
steve004: 5901
1873man: 5011
deerhunter: 3079
twobit: 2765
Big Larry: 2578
mrcvs: 2553
Zebulon: 2531
Newest Members:
Robby
Richard E. Sharp
BEVOinMaine
Win-man65
Banjo
Gary Reighard
Dirtcurt
HEISAP
Jetskibratttt
Forum Stats:
Groups: 1
Forums: 18
Topics: 16482
Posts: 151066
Member Stats:
Guest Posters: 2057
Members: 11093
Moderators: 3
Admins: 4
Administrators: Mike Hager, Bert H., JWA, SethJ
Moderators: Rob Kassab, Brad Dunbar, Heather
© Simple:Press —
Log In
