sixguns
Member
WACA Member
Forum Posts: 40
Member Since:
January 31, 2008
January 31, 2008
OfflineIs there a gap width minimum for an 1886 Takedown. I believe the gap in my 86 is a bit to wide as the result of the prior owner adjusting the takedown extension screws too far out. I can just about see a little daylight mostly at the bottom of the receiver.
Any suggestions would be greatly appreciated ?
Angel
1873man
Wisconsin
Member
WACA Member
Forum Posts: 5011
Member Since:
May 2, 2009
May 2, 2009
OfflineThe adjuster screws are turned in just enough so the barrel gets tight when its lined up. The screws push the metal out so you will get a gap and I have never heard of a limit to the gap. I have seen people put shim stock between there when they didn’t know about the screws which does the same thing.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's

Email: [email protected]
Forum Timezone: UTC 0
Most Users Ever Online: 21294
Currently Online: antler1, Anthony #5411, TXGunNut, markone1966
Guest(s) 103
Currently Browsing this Page:
1 Guest(s)
1 Guest(s)
Top Posters:
TXGunNut: 7772
clarence: 7119
Chuck: 6931
steve004: 5901
1873man: 5011
deerhunter: 3079
twobit: 2765
Big Larry: 2578
mrcvs: 2553
Zebulon: 2530
Newest Members:
Richard E. Sharp
BEVOinMaine
Win-man65
Banjo
Gary Reighard
Dirtcurt
HEISAP
Jetskibratttt
Dermot
Forum Stats:
Groups: 1
Forums: 18
Topics: 16482
Posts: 151062
Member Stats:
Guest Posters: 2057
Members: 11093
Moderators: 3
Admins: 4
Administrators: Mike Hager, Bert H., JWA, SethJ
Moderators: Rob Kassab, Brad Dunbar, Heather
© Simple:Press —
Log In
