Log In
February 5, 2016
Offline
Picked up a nice little Model 1873 SRC. In the process of getting ready to dissemble it the sling ring pulled out. Is this common? What is the fix? My first SRC.
Thanks
Kirk
May 2, 2009
Offline
Kirk,
So the staple pulled out of the receiver?
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
November 1, 2013
Offline
Kirk Fitzgerald said
What is the fix?
EPOXY!
May 21, 2015
Offline
Kirk. You may as well do it properly. Take the bottom tang out, put the staple back in place, hold staple firmly in against receiver. Now put the end of a 1/4″ punch against the forward leg of the staple and bump forward. Only one leg of staple needs doing. Staple should extend through through frame by about 1/16″ You could put some Locktite on it but not needed. Cheers Eric
February 5, 2016
Offline
Thanks all,
Yes the staple came out. I am going to dissemble the gun today to clean it. So I am going to try Eric’s punch fix as I think I understand the mechanics of the solution.
Cheers
Kirk
1 Guest(s)
