Log In
Link not flush with frame
pine_worker
Member
WACA Member
Forum Posts: 133
Member Since:
February 1, 2013
February 1, 2013
Offline1
January 23, 2023 - 7:53 pm
I am looking at a 1952 Model 94 and noticed the link protrudes about 3/32” and is not flush with the frame when the lever is closed. Is this normal? What could cause this? I have a 1940, 1951 and 1956 model 94’s, all of these the link is flush with the frame. The sides of the hammer are also a plume color which makes me think someone has reblued/replaced the hammer. Any thoughts?
pine_worker
Member
WACA Member
Forum Posts: 133
Member Since:
February 1, 2013
February 1, 2013
Offline2
January 28, 2023 - 6:51 pm
Admin, could you move this post to the repair and maintenance forum? Thanks.
Ken Windeler
Member
WACA Guest
Forum Posts: 70
Member Since:
June 24, 2016
June 24, 2016
Offline3
February 18, 2023 - 5:15 pm
Is the locking bolt low in the frame also?
The link plunger or spring might be worn and not holding the link up. Depending on the final polishing some 94s do not have quite an even fit, but the rear end of the link should be pretty much flush with the frame lower tang.
Forum Timezone: UTC 0
Most Users Ever Online: 5406
Currently Online:
Guest(s) 547
Currently Browsing this Page:
1 Guest(s)
1 Guest(s)
Top Posters:
clarence: 7119
TXGunNut: 6964
Chuck: 6305
steve004: 5432
1873man: 4810
deerhunter: 2810
twobit: 2600
Big Larry: 2578
mrcvs: 2312
Maverick: 2128
Newest Members:
Gunfreak
winchester71forever
Barrelandblade
MIW
abb321
HenryLee
Bill McLaren
AdamFahim
Hayleeandmichelesdad
M1garandbill
Forum Stats:
Groups: 1
Forums: 18
Topics: 15388
Posts: 139031
Member Stats:
Guest Posters: 2057
Members: 10377
Moderators: 3
Admins: 4
Administrators: Mike Hager, Bert H., JWA, SethJ
Moderators: Rob Kassab, Brad Dunbar, Heather
© Simple:Press —