Log In
May 2, 2009
Offline
After the upgrade that just happened we lost a couple days of posts. Also private messages lost a couple days. You must of used a old backup when you loaded the new server.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
April 20, 2011
Offline
i listed a 92 with stainless steel barrel for sale and the listing disappered. i’ll try again
February 5, 2016
Offline
I several long posts this morning. Not a good way to operate this site
Cheers
Kirk
May 2, 2009
Offline
Gregg,
I copied and pasted the topic about barrel lengths back to the rifles forum. Here is the link
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
April 15, 2005
Offline
Gentlemen,
I have informed the persons responsible about this issue. I can not make any promises that we will get a full restoration of the lost posts (several of which were mine).
Bert
WACA Historian & Board of Director Member #6571L
May 2, 2009
Offline
Bert,
Any PM’s that happened during that time are also gone.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
January 19, 2006
Offline
I have an automation that emails me all new posts very soon after they are posted (I don’t like to miss anything!). If anyone has an important or long post that they lost, I may have it and can send you the text so you can repost (or repost it for you). I trash stuff when I read it, but I think most of my trash is still there.
PM me or email at [email protected]
WACA Member. CFM Member. NRA Lifer.
January 17, 2016
Offline
Thanks 1873man and Mike hunter .Present screw is frozen by corrosion,Trying pb blaster and heat and patience now, but that fine thread may mean it is welded with rust. Could leave alone and clean mag tube by removing it.
January 24, 2013
Offline
#6 screw, 48 threads per inch; .200 head dia, .030 screw slot.
OOps looks like Bob and I were posting at the same time
May 2, 2009
Offline
major diameter of .137″ x 48 tpi which is close to 6-48
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
January 17, 2016
Offline
Does anyone know the size and thread pitch of the short version magazine plug screw[where the hole is blind ,not going through to the barrel] ?
February 8, 2005
Offline
Gentlemen,
I think you might get better answers to parts and hardware issues in the appropriate forums rather than these administrative forums.
Please reserve this forum for issues, problems and questions about the operation of forum features.
Thank you!
Michael Hager
Forum Administrator
May 2, 2009
Offline
Mike,
These posts about thread size where posted in the other forum but probable disappeared during the upgrade and somehow got reposted here out of sequence if you look at the time of post.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
1 Guest(s)
