Volcanic pistol help|General Discussions & Questions|Forum|Winchester Collector

Hi everyone

I have recently acquired a volcanic pistol, it has a few issues, some have been sorted out and a couple remaining.

Where I am at now is that I have to fabricate a finger lever and follower for the magazine, as well,

I need a spring.

There is also a missing part on the nose of the pistol that needs to be fabricated, not sure what it is called but I believe it is

to lock and unlock (i believe) the barrel. not sure.

If anyone can help me that would be much appreciated, I would like to have some photos and measurements.

not sure if this is possible but I have to start somewhere.

thx Sean