model 1901|Winchester Shotguns|Forum|Winchester Collector

Avatar
sp_LogInOut Log In
sp_Search Search
Advanced Search
Search
Forum Scope



Match



Forum Options



Minimum search word length is 3 characters - maximum search word length is 84 characters
sp_Search Search
Lost password?
sp_Feed sp_PrintTopic sp_TopicIcon
model 1901
Avatar
Al Peterson
Guest
Guests
1
March 7, 2015 - 6:29 pm
sp_Permalink sp_Print

Can someone please help me find a breakdown drawing for a 10 ga 1901. I have been shooting this one for a while with low pressure RST ammo and removed the two piece fore end to inspect the outside of the barrel. I was surprised to see a small relief in the barrel and magazine tube where the fore end screws pass through. Did Winchester do this?

Avatar
Bert H.
Kingston, WA
Admin
Forum Posts: 14908
Member Since:
April 15, 2005
sp_UserOfflineSmall Offline
2
March 7, 2015 - 7:01 pm
sp_Permalink sp_Print

Hello Al,

Yes, Winchester milled the relief groove in the barrel and magazine tube.  The was a common practice that was used on numerous models.

Bert

WACA Historian & Board of Director Member #6571L
High-walls-1-002-C-reduced2.jpg

sp_Feed
Go to top
Forum Timezone: UTC 0
Most Users Ever Online: 21294
Currently Online: Rick Hill, Manuel, Henry Mero, Roger Adam, Lawrence Clarey, Ben, Jeremy P, Pony trekker, jmarksnsx, Hightime
Guest(s) 1452
Currently Browsing this Page:
1 Guest(s)
Top Posters:
TXGunNut: 7719
clarence: 7119
Chuck: 6908
steve004: 5876
1873man: 5000
deerhunter: 3077
twobit: 2760
Big Larry: 2578
mrcvs: 2536
Zebulon: 2492
Newest Members:
Malamute
murph
jwww
Rodney Swillie
Teemdoc
Craig Sidwell
IndianCent
Hightime
Corvette2008
rsd
Forum Stats:
Groups: 1
Forums: 18
Topics: 16414
Posts: 150425

 

Member Stats:
Guest Posters: 2057
Members: 11056
Moderators: 3
Admins: 4
Administrators: Mike Hager, Bert H., JWA, SethJ
Moderators: Rob Kassab, Brad Dunbar, Heather

© Copyright 2026 Winchester Collector

Navigation