Log In
April 18, 2012
Offline
I’m here in Vermont at a Cowboy Action Shoot. I’m sighting in my Mirkou Winchester 1894 rifle in 38-55….Everything is going great. I get ready to put the rifle back in the case and a part falls out of the bottom. I searched all parts drawings I could find here on the internet with no luck.
Can anyone identify this part and tell me where it belongs
May 2, 2009
Offline
If it still works then you don’t need it !, I have no idea on a gun that new.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
December 27, 2007
Offline
Looks as if you might be missing a pin or a screw that your part pivots on. Also looks as if a spring might go on that finger, so possibly a part of your hammer/trigger assembly? Guesses from here; I’ve never seen a Mirkou Winchester.
Why not take the rifle apart and let your part guide you to where it is to fit? Can’t be too many places in your rifle a part like that will snuggle into.
November 7, 2015
Offline
All I can figure is that if the part in the pic is from your gun you’re missing at least one more part. If it won’t feed I’d say it’s backup rifle time. Hoping for the best for you!
December 27, 2007
Offline
May we have a photo or an indication from you of the size of this part?
If it is small, perhaps it is from off the underside of the bolt–but how do parts just fall out of 94’s? (More likely your friend with a 3D printer created a phantom part, slipped it on your rifle so it would easily fall off, and is laughing right now. Or–YOU have the printer and are toying with us!)
Also, after looking at Miroku 94’s, is yours an AE? As I said, I don’t know about the modern ones, but I do enjoy a scavenger hunt.
May 2, 2009
Offline
That is why I like the old guns, part don’t fall out of them.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
April 18, 2012
Offline
Found it! It’s the ejector. Now I just have to figure out how to put it back in and where the spring and pin are….
https://www.rebelgunworks.net/products/winchester-94-post-64-pre-64-rifle-ejector
1 Guest(s)
