Log In
Low wall
Robert Lile
New Member
WACA Guest
Forum Posts: 1
Member Since:
September 3, 2015
September 3, 2015
Offline1
April 29, 2017 - 3:27 pm
Recently acquired a 22 short Low Wall. It was a semi basket case, had to make a knock off pin and a trigger spring for it. It has a problem when the action is fully open the hammer drops too far into the receiver and falls back slightly so the action can’t be closed. It’s a project gun but I would like to make it functional. Any ideas? Robert
Bert H.
Kingston, WA
Admin
Forum Posts: 14771
Member Since:
April 15, 2005
April 15, 2005
Offline2
April 29, 2017 - 9:19 pm
Robert,
My advice is to find original or correct reproduction parts versus using homemade parts. I can’t diagnose what is wrong without having the rifle in hand.
Bert
WACA Historian & Board of Director Member #6571L
Forum Timezone: UTC 0
Most Users Ever Online: 21294
Currently Online: winchester73, cj57, JWA, tsillik, deerhunter, Roger Adam, Ben, [email protected], Chuck Ellison, Peter S, Fedelsur
Guest(s) 442
Currently Browsing this Page:
1 Guest(s)
1 Guest(s)
Top Posters:
TXGunNut: 7640
clarence: 7119
Chuck: 6867
steve004: 5845
1873man: 4993
deerhunter: 3070
twobit: 2741
Big Larry: 2578
mrcvs: 2518
Zebulon: 2392
Newest Members:
TonyG
Tinman770
Joe7039
RGiertz86
Les Thanadequate
Barry59
Bear
Anthony Eisenlohr
kik595
DavidM
Forum Stats:
Groups: 1
Forums: 18
Topics: 16297
Posts: 149148
Member Stats:
Guest Posters: 2057
Members: 10984
Moderators: 3
Admins: 4
Administrators: Mike Hager, Bert H., JWA, SethJ
Moderators: Rob Kassab, Brad Dunbar, Heather
© Simple:Press —