Log In
September 23, 2021
Offline
Put new carrier spring in and cycled fine a few times.wasn’t dropping down into notch on lifter arm.Now it locks up when carrier is raised and spring drops in notch.never worked on ’73 before and end of spring was broke off.if I push down on the carrier while leverling it it will break loose.I guess it’s supposed to drop in the notch.any ideas?
thanks, Pete
May 2, 2009
Offline
Pete,
Here is a picture of what it should look like with the spring in the notch. What does your look like.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
September 23, 2021
Offline
Bob,
Not much of a picture taker but here it is…………….well, maybe not.Can’t figger out how to send it! Doesn’t drop down in
notch as much as yours. Maybe need more bend on spring or so much wear on parts something else is going on.
I’ll try some more on pic later.
Pete
May 2, 2009
Offline
Pete, as a guest you can’t post directly to the site. You have to post to a third party host site and then link to it. You can also email them to me at the below address.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
September 23, 2021
Offline
Bob,
Tried sending pic by email on phone.replacement spring doesn’t have as much bend as original making it .046 longer.can spring be bent without much chance of breaking or relieve notch in lifter?
Pete
May 2, 2009
Offline
Pete,
Tthe email photo you sent has a weird file type which didn’t open. You can’t bend a spring without a good chance it will break.
Bob
WACA Life Member--- NRA Life Member---- Cody Firearms member since 1991 Researching the Winchester 1873's
Email: [email protected]
1 Guest(s)
